Trae Lyx Floor Lacquer Satin Finish

Trae-Lyx Floor Lacquer is a water-based, fast-drying, single-component lacquer based on a polyurethane dispersion. The lacquer is virtually odourless. The fully cured layer is highly resistant to wear and impact, non-yellowing, permanently flexible and resistant to common household chemicals. Trae-Lyx Floor Lacquer has very good resistance to point loading.

APPLICATION

Suitable for softer woods such as pine and spruce.
Due to its clear appearance, it is highly suitable for preserving the natural colour of softer woods. For indoor use only.

PROPERTIES

Gloss level: Matt and satin
Colour: Transparent clear
Solids content: Approx. 32% by weight 
Solvent content per litre: 3.8 %
Volatile organic compounds per litre: 1.4% (14 g/l)
Theoretical coverage: Approx. 10 - 15 m²/l
Flash point: None
Specific gravity: Approx. 1.03 kg/l
Viscosity (18°C): 35-40 sec. DIN Cup 4 mm
Touch dry: After approx. 30 min at 20°C and 65% R.H.
Recoatable: After approx. 2 hours at 20°C and 65% R.H.
Trafficable: After approx. 12 hours at 20°C and 65% R.H.
Fully cured: After approx. 7 days at 18°C and 65% R.H.
Packaging: 750 ml, 2.5 and 10 litres
Storage: Dry and frost-free
Shelf life in the can: 2 years at a temperature between 5 and 25°C, in the original unopened packaging

APPLICATION DATA

Application method: Acrylic brush or a 7-9 mm microfibre roller (100 MU).
Application:

• Stir the lacquer thoroughly before use.
• When using multiple cans per coat, combine them first and stir thoroughly
• Do not apply at a temperature lower than +5°C and/or a relative humidity higher than 80%.
• Good ventilation promotes drying.

Type of thinner: Water
Thinning percentage: Prefer not to thin
Dry film thickness: 100 - 120 microns
Number of coats: Apply 3 - 4 coats
Application conditions: Min. 5°C and max. 80% R.H. Ensure sufficient air circulation
Cleaning tools: With warm water

GENERAL PREPARATION

The substrate must be clean, dry and free from grease and wax.
Thoroughly remove wax and grease from old layers and sand lightly if necessary.
If the old layer is from a different manufacturer, make a test stroke to ensure good adhesion.

MAINTENANCE

Trae-Lyx Floor Lacquer should be maintained with Trae-Lyx maintenance products.

SPECIAL INSTRUCTIONS

DO NOT use on acid- or moisture-curing PU lacquers.